Wire harness for:
All Performance and Classic line tachometers
Voltage Gauges (Voltmeter)
Air-fuel Gauges (narrow and wideband)
The EGT Amplifier Box is for the Dual Channel EGT gauge. The EGT Amplifier Box conditions and amplifies the signal from a Type K thermocouple into a useful signal which can be used with our Dual Channel EGT gauge. (Type K thermocouple not included, this...
A single power cable link
Use this 3-foot extension cable to extend power cable for maximum flexibility.
Connect up to 8 gauges along this daisy-chain power cable.
Compatible with all gauge lines.
Included with all orders of 3+ gauges.
Connect multiple gauges to the CAN-BUS system of your vehicle. Works with our Freedom gauge series. Saves you time wiring up your gauges.
Wire harness for the Freedom CAN-BUS gauges. Exposed leads on end connect to CAN-BUS system. Specify length below when ordering. Special lengths available upon request. Use this harness to Easily 'hard wire' into CAN high and low data lines to free up...
Wire harness for the Freedom CAN-BUS gauges. This harness comes with the OBDII connector. Specify length below when ordering. Special lengths available upon request. NOTE: Speedhut Freedom CAN-BUS gauges (individual or daisy chained) will not function...
Gauge programming button for programming any gauge that does not have a button on the front of gauge for programming. Works with all gauges that have a 3.5mm jack port on the back of gauge for programming the gauge instead of the button on the front of...
In-line Fuse - Use in line with up to 10 Speedhut gauges.
20 AWG Wire
Includes 2 butt splice connectors
Cut the wire in half
Strip both ends
Use Butt Splicers for the connections
Lynx Splitter Module for Can-Am allows for three Lynx Gauges for Can-Am to be connected to one diagnostic plug. Or use two splitters to connect a maximum of five gauges to one diagnostic plug.
LYNX Splitter Polaris Module for 4 wire Diagnostic plug allows for three Lynx Gauges for select Polaris models to be connected to one diagnostic plug. Or use two splitters to connect a maximum of five gauges to one diagnostic plug.